Up to this point, we have only disc

Up to this point, we have only discussed splicing optical fibers that have been cleaved so the endface is perpendicular to the optical fiber. However, angled mechanical splices that offer better return loss performance than traditional mechanical splices are being introduced. Return loss is covered in detail in Chapter 29, “Passive Components and Multiplexers.”

Angled mechanical splices require a special cleaver, angle cleaved fiber holders, and a special mechanical splice. The special cleaver like the one shown in Figure 25.27 places a 7o angle on the fiber endface while the angle cleaved fiber holders maintain the orientation of the cleave. Maintaining the orientation of the cleaved fibers is critical so that they align properly inside the mechanical splice.

Hasil (Bahasa Indonesia) 2:

Sampai saat ini, kita hanya membahas splicing optik? Serat yang telah dibelah sehingga endface yang tegak lurus terhadap optik? Serat. Namun, splices mekanik miring yang menawarkan kinerja yang lebih baik loss kembali dari splices mekanis tradisional sedang diperkenalkan. Return loss dibahas secara rinci dalam Bab 29, "Komponen Pasif dan multiplexer." splices mekanik lekukan membutuhkan pisau khusus, sudut dibelah? pemegang serat, dan sambatan mekanik khusus. Golok khusus seperti yang ditunjukkan pada Gambar 25.27 tempat sudut 7o pada? Serat endface sedangkan sudut dibelah? Pemegang serat mempertahankan orientasi membelah tersebut. Mempertahankan orientasi serat dibelah? Sangat penting sehingga mereka menyelaraskan dengan baik dalam sambatan mekanik.