Hasil (
Bahasa Indonesia) 1:
[Salinan]Disalin!
GENERAL TORQUE LIMITS THREADSIZEPOUNDS TORQUE INCH-6-32......Bolts and nuts.................................5 TO 88-32......Screws,bolts, and nuts.........................10 to 15When the torque limits are specific to the maintenance procedure,they will be included in the procedure. When torque limits are not included in the maintenance procedure, the general torque limits chart may be used.Figure,tables, and charts of torque limits can be found in the TOs. you muts use these figure, tables, and chart when the torque limits are not specified in the assembly instruction. TO 2J-T56-26 gives this information in Section VII, table of limits.TO 1C-130B-10 gives information is Section II, Buildup Instructions. TO 1C-130B-2-4 gives this information in section I, general information. TO 1C-1-1A-8 includes information for most types of general hardware.
Sedang diterjemahkan, harap tunggu..